1-5. Install Makey:bit
Follow These Steps
1. Peek at the Pins
First, let's check out the pins on the back of your Makey:bit! This is where you’ll plug in your servo motor cables. Need a closer look? Take a peek at the cards that came with your kit.
2. Pop In the Makey:bit
Now get your Makey:bit in place! Slide it through the large hole in the center of your monster’s base, starting from the front. Gently push it into place. It's almost monster time!
3. Plug In the Power
Now that your Makey:bit is in place, flip your monster over so you can see the back side.
Find the cable from your 180-degree servo motor and get it ready. Make sure the brown wire is on the right side.
Plug it into the three pins on the bottom left of your Makey:bit, with the brown wire still on the right.
Here’s a quick reminder: Brown (-) goes to GND Yellow (signal) goes to P0
Nice and neat!
SEE IT IN ACTION
Materials:
- 1 x Monster base + stand + 180-degree servo motor
- 1 x Makey:bit microcontroller
