2-2. Install Side Wheels onto Grabbe’s Servo Motors
Follow These Steps
1. Line Up Your Servos
First, grab all the parts you need. Check out the first photo to make sure you’ve got everything ready to go! Then line up your servo motors on each side as pictured here.
2. Snap Wheels onto the Servos
Grab a wheel and snap it onto the shaft of each servo motor. Make sure the flat side in the center of the wheel is facing the servo shaft, then press until it clicks into place.
Now you should have one wheel attached to each servo motor and you'll soon be ready to roll!
SEE IT IN ACTION
Materials:
- 1 x Base with stand, 180-degree servo, and ball roller already installed
- 2 x Continuous servo motors
- 4 x Nylon bolts - lay them out and prepare to use in next module
- 4 x Nylon nuts - lay them out and prepare to use in next module
